96
Power supply:
Power supply cord kit:
3 wire , 120 volt , 30 amp, 60Hz, 1 phase
(Not supplied when sold in the United States) the dryer MUST employ a 3-conductor power supply cord NEMA
10-30 type SRDT rated at 120 Volt AC minimum, 30 Amp, with 3 open end spade lug connectors with upturned
ends or closed loop connectors and marked for use with clothes dryer.
Use only 4 inch (10.2.cm) diameter (minimum) rigid or flexible
metal duct and approved vent hood which has a swing-out damper
hat open when the dryer is in operation . When the dryer stops, the
dampers automatically close to prevent drafts and the entrance of
insects and rodents . To avoid restricting the outlet, maintain a
minium of 12 inches ( 30.5 cm) clearance between the vent hood
and the ground or any other obstruction . The vent flap should be able to remove freely.
Select a suitable location for the dryer on a hard even surface away from direct sunlight or heat
source e.g. Radiators, baseboard heaters, cooking appliances etc . Any floor unevenness
should be corrected with leveling legs located on the bottom of the dryer.
1) remove all packaging material . This includes the foam base and all adhensive tape holding the dryer
acessories inside and outside.
2) inspect and remove any remains of packing, tape or printed material before using the dryer.
7 Key points in installation, adjustment and disassembly
C
C
C
Tools and materials required
Electrical requirements
Unpacking your dryer
Materials
Exhaust system connections
Measuring tape ( 12ft.min.)
Duct tape
Rigid or flexible metal 4 inch ( 10.2 cm) duct
Vent hood
Phillips head and flathead screwdrivers
Channel-lock adjustable pliers
1 2 inch open end wrench
Carpenter s level
'
CORRECT
INSTALL MALE FITTINGS IN CORRECT DIRECTION
INCORRECT
MAXIMUM LENGTH
of 4''(10.2cm)Dia.Rigid Metal Duct
VENT HOOD TYPE
(Preferred)
Louvered
Number
of
90
turns
60ft. (18.28 m)
48ft.(14.63
m)
52ft. (15.84 m)
40ft.(12.19 m)
44ft. (13.41 m)
32ft.(9.75 m)
32ft. (9.75 m)
24ft.(7.31 m)
28ft. (8.53 m)
21/2''
4''
(6.35 cm)
(10.2 cm)
16ft.(4.87 m)
MAXIMUM LENGTH
of 4''(10.2cm)Dia.Flexible Metal Duct
VENT HOOD TYPE
Louvered
(Preferred)
Number
of
90
turns
30ft. (9.14 m)
18ft.(5.49
m)
22ft. (6.71 m)
14ft.(4.27 m)
14ft. (4.27 m)
10ft.(3.05 m)
21/2''
4''
(6.35 cm)
(10.2 cm)
0
2
1
3
4
0
2
1
Service Manual
Model No. CGDE480BW
Issue
Rev.
