Haier 2HUM18HC003, Руководство по эксплуатации

Страница: 9 / 22

Trouble shooting
Normal
performance
inspection
Noise is heard
Phenomenon Cause or check points
The system
immediately.
Odors are present
Mist or steam are
Multiple
check
Poor cooling
When unit is stopped, it won't restart
elapsed to protect the system.
When the electric plug is pulled out
and reinserted, the protection circuit
During unit operation or at stop,
a swishing or gurgling noise may
(This noise is generated by
refrigerant flowing in the system.)
Should there be a big noise from
filter may be too dirty.
The system circulates any remaining
odors.
During COOL or DRY operation,
This is due to the sudden cooling
Is the power chord correctly position in
the outlet?
Is there a power failure?
Has a fuse or circuit breaker been
tripped?
Is the air filter dirty?
Are there any obstacles in front of
Is temperature set correctly?
Are there some doors or
Is there any direct sunlight
through the window during the
Are there too many heat sources or too
many people in the room during cooling?
In dry mode, fan
speed can’t be
changed.
In DRY mode, when room temperature
2
o
C,unit will run
regardless of FAN setting.
cooling operation?(Use curtain)
windows left open?
inlet and outlet?
Normally it should be cleaned
every 14 days.
intermittently at LOW speed
becomes lower than temp.
indoor unit may blow out mist.
of indoor air.
air flow in unit operation, air
be heard.At first 2-3 minutes after
unit start, this noise is more noticeable.
will work for 3 minutes to protect the
air conditioner.
immediately until 3 minutes have
Cautions
Do not obstruct or cover the ventilation
conditoner.Do not put fingers
inlet/outlet and swing louver.
Do not allow children to play with the air conditioner
case should children be allowed to sit on the outdoor unit.
1.Applicable ambient temperature range:
Specifications
The machine is adaptive in following situation
The power plug and connecting cable
acquired the local
2. If the power supply cord is damaged, it must be replaced
manufacturer
3. All electrical wiring must be done to applicable local and state codes.
4. An electrical outlet must be within distance of the indoor unit.
5. When replacing batteries, the batteries removed should be disposed
of properly.
6. Assure that the proper outlet is being used with the power cord.
8. In order to protect the units,please turn off the unit first, wait 30
seconds and turn off the power.
7.
grille of the air
or any objects into the
.In no
or its service agent.
must have
Before calling for service, check the following
first.
blown out.
does not restart
by the
attestation.
7
The refrigerating circuit is a sealed system.
Cooling
Indoor
Maximum:D.B/W.B
Maximum:D.B/W.B
D.B
Maximum:D.B
D.B
Minimum:D.B/W.B
Maximum:D.B/W.B
Minimum:D.B/W.B
Outdoor
Indoor
Outdoor
Heating
89.6 /73.4
75 /65
115 /75
80.6
67 /57
Outdoor
Maximum:D.B/W.B
Minimum:D.B
5
(INVERTER)
32
Minimum:
Minimum:
67 /57
75 /65
19.4