1
1
0
0
Heat Pump (2 Stage Heat / 1 Stage Cool)
24VAC Common*
24VAC "HOT"
Auxilirary Heat
Compressor
Ground Fault
Humidifier
Fan
Dehumidier
Compressor Relay
Aux Heat Relay
Fan Relay
Humidifier
Fault Relay
Dehumidifier
Reversing Valve
Energized in Cool
Energized in Heat
24VAC
CONTROL
TRANSMFOMER
THERMOSTAT
UP
HVAC SYSTEM
12
11
7
6
8
3
1
(D)
(H)
(G)
(Y1)
(B)
(C)
(RC)
4
5
9
(O)
(W2)
(L)
Figure 9
–
Connections for heat pump thermostat
CONFIGURATION
¾
The “System Type” for this thermostat must be set to “Heat Pump” under
“System Options”
.
¾
The “System Type” for this thermostat must be set to “Dual Fuel Heat Pump” for a dual fuel system
(Terminal “W2” is connected to the “W” or “W1” on the furnace).
POWER UP
1.
Double check wiring, be sure that there
are
no stray wires or wire strands at the connections.
2.
Connect power to the transformer and system. The display will show all of the thermostat settings.
3.
Press [FAN] and select “On”. The fan should come on.
4.
Press [FAN] and select “Auto”. The fan should go off.
5.
Press [HOLD] and select “On” to override Energy Efficient Control.
6.
Set the Mode to "Heat". Raise the desired heat setting 1 degree above the current temperature. Ensure
that the heat pump comes on, in heating mode. After a few minutes, raise the desired heat setting 3
degrees above the current temperature. Auxiliary heat should come on. After a few minutes, set the
mode to "EM Heat". The heat pump should stop but the auxiliary heat should remain on. Set the mode to
“Off”. Ensure that both the heat pump and auxiliary heat go off.
7.
Set the Mode to "Cool". Lower the desired cool setting below the current temperature.
Ensure that the
heat pump comes on, in cooling mode. Set the mode to "Off". Ensure that the cooling unit goes off.
8.
Press [HOLD] and select “Off” to enable Energy Efficient Control.
