HAI OMNISTAT RC-112BZ, Руководство по установке, Страница: 6 / 16

6
6
CONFIGURING THE BACKLIGHT ON THE RC-112BZ
The backlight on the RC-112BZ can be configured to one of three different modes: 1) on for 30 seconds when a
key is pressed, 2) always on, or 3) always off.
1)
To configure the display backlight to turn on when a key is pressed, then back off 30 seconds later, set
the “JP2” (Select Backlight Mode) jumper to the “TIMED” position (between the top and middle pin on
the connector) -
See Figure 6.
2) To configure the display backlight to always be on, set the “JP2” (Select Backlight Mode) jumper to the
“ON” position (between the middle and bottom pin on the connector) -
See Figure 6 .
3)
To configure the display backlight to never come on (always off), remove the “JP2” (Select Backlight
Mode) jumper from the connector -
See Figure 6 .
DISABLE KEYS
The keys on the thermostat can be disabled to prevent anyone from controlling the thermostat locally. To
disable the keys, solder a wire jumper across “JP1” (two holes on the circuit board) -
See Figure 6 .
SOLDER WIRE JUMPER HERE
SELECT BACKLIGHT
MODE (SET JUMPER)
TO DISABLE KEYS LOCALLY
Figure 6