WaterMax ST Series Owner’s Manual
5/11/2018
36
Assembly and Parts, Cont.
Brine Valve Housing Assembly
Figure 16: Brine Valve Housing Assembly
Part #
Description
Quantity
1
53511
Piston Assembly (includes O-Ring & Spring)
1
2
90821
O-Ring
1
3
53510
Housing
1
4
90843
0.5 gpm Flow Control
1
5
93805
O-Ring
1
6
93247
Housing End Cap
1
7
90818
Screw, self-tapping
2
8
200199
3/8-inch Locking Clip
1
99699
Entire Assembly (all of the above parts)
53511 Brine
Piston
The Piston should have an O-Ring on the shaft side of the flange and a spring pressed onto a boss on
the other side. The O-Ring should be free of defects such as cuts or debris on the shaft side.
53510 Housing
Just inside the entrance hole for the Brine Piston is a concave seat area that must be free of defects
such as nicks, indentations, or debris. This seat area ensures a leak-free seal for the static O-Ring on
the Brine Piston. If any defects are detected by visual inspection, repair or replace as needed.
90843 0.5 gpm
Flow Control
The Flow Button has two distinct and different sides. One is “flat”; the other is “concave.” The button
should be centered in the housing opening with the four locator “ribs” with the concave side facing the
Housing End Cap.
93247 Housing
End Cap
The Cap is held in place by two 3/4-inch self-tapping screws that engage the Housing flange. An
O-Ring seals the Cap and Housing. Place the O-Ring onto the housing end cap, lubricate with silicone
grease and then using a twisting action, insert the Cap into the housing.
Caution: The 3/8-inch locking clip must be installed to prevent air from being drawn into the appliance
during brine rinse.
Static O-Ring
Concave Side
Содержание WaterMax ST Series
Страница 1: ...WATER CONDITIONING APPLIANCE ST SERIES OWNER S MANUAL AND INSTALLATION GUIDE VERSION 1 1...
Страница 45: ...WaterMax ST Series Owner s Manual 5 11 2018 45 Certificates...
Страница 46: ...WaterMax ST Series Owner s Manual 5 11 2018 46 Certificates Cont...
Страница 47: ...WaterMax ST Series Owner s Manual 5 11 2018 47 Notes...