26
Maximizer
®
97 Owner’s Manual
OR-05/18/15
Quality Water International
®
Assembly and Parts
Drive End Cap
1
2
3
4
5
6
7
8
9
10
11
12
13
3
15
16
17
18
14
Part #
Description
Qty.
Note
1
90802
Screw
2
2
90217
Drive Motor
1
The motor is held in place by two 1/2-inch self-tapping screws.
The screws should be “snug.” The brass pinion gear on the motor
should engage the plastic drive gear. The wires should be securely
fastened to the control.
3
93891
1/4-inch Hex Nut
2
4
93238
Drive Gear
1
The drive gear is assembled to the slide cam by means of a “keyed”
opening which transfers the “torque” generated by the motor to the
rest of the drive system. If the drive system becomes jammed, this
opening can become “rounded” causing the gear to turn, but not the
piston slide cam. If this occurs, clear the jam and replace the drive
gear and piston slide cam.
5
90809
Screw
Self-Tapping
2
6
93219
Piston Slide
Cam Cover
1
The cover secures the piston slide cam in place and acts as a
bushing for the cam shaft.
7
93217
Piston Slide Cam
1
This is the “heart” of the drive system. There is a threaded stainless
steel shaft that runs through the main drive axle. The drive gear is
attached at the short end and the magnet disc at the other end. The
slide cam is assembled inside of the piston slide. This cam shaft
should turn freely before the motor is assembled.
Figure 9: Drive End Assembly
