HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]
Safety instructions
Risk of falling! When installing the beamer on the lift it might fall down. To attach the beamer to
the lift, you may need a platform or a ladder for each person. A platform is preferable to a ladder.
Make sure that the platform and / or the ladder is secure.
Danger of falling of the beamer on bystanders during operation. Fix the beamer.
Make sure that the beamer including the plugged-in cable does not protrude beyond the permit-
ted installation space in order to avoid collisions between the projector and the lift or surroun-
ding components during operation.
Risk of shear due to surprising start of the lift while installing the beamer. If the ceiling mount
starts up unexpectedly during the installation process, fingers could be sheared off. Before
installing the beamer, disconnect the ceiling mount from the power supply and put the plug in
sight so that you can supervise it immediately to prevent unauthorized insertion. Move the lift to
the lower position before separating the energy connection.
Risk of electric shock! If the beamers power cable gets into the mechanics of the lift, this can
damage the cable insulation and make parts of the lift conductive. It is therefore essential to
route the cables in the energy supply chain.
Installation of the ceiling frame or a lower cover
•
Move the lift to the lowest position.
•
Cover the underside directly or with the threaded rods and the installation frame.
•
Slowly raise the projector lift with the remote control. At the end, adjust the
threaded rods so that the mounting frame is flush with the rest of the ceiling.
•
Pay attention to maximum load capacity of the lift.
•
Check the positioning by a test run of the lift and make sure that it fits into the
suspended ceiling without resistance. If necessary, adjust until the panel fits
exactly into the inserts.
Direct cladding on hanging projectors
•
Move the lift to the lowest position.
•
Cover the underside directly or with the threaded rods and the installation frame.
•
Check the length of the supplied threaded rods and bring them to the desired
length if necessary. Make sure there is sufficient space between the beamer and
the ceiling frame so that you have the option of changing the installation height if
necessary.