hager WDI07 series, Руководство пользователя

Страница: 22 / 108

Connecting and installing the device
The RJ45 installing connector is mounted on the network cable.
z
Connect the jack to an RJ45 socket on the touch panel (7/8) using the
enclosed, pre-assembled RJ45 patch cable.
z
If required connect a 24 V DV auxiliary voltage (see Accessories) using the
enclosed terminal (9). Ensure correct polarity (fi gure 2/3).
Recommendations for connecting the supply voltage, see Prepare the
supply voltage.
z
Insert touch panel in the housing (21) in such a way that the mounting
plates (22) of the housing are pushed under the frame.
z
Tighten the four screws and the mounting plates through the frame from
above and below using the enclosed Allen key (Figure 12/13).
The screws must be countersunk in the frame.
(21)
(22)
(22)
Figure 12 a/b: Installation in the fl ush-mounted housing
(21) Flush-mounted housing (not included in scope of delivery)
(22) Mounting brackets
z
22