Date : 20/09/2012
6T 8207-02a
tebis touch panel User Manual
USE
10
SHUTTER POSITION: This command is used to open,
close and set the position of the shutters. Setting is done in
2 different ways:
- By pressing the
and
symbols.
- By sliding your finger over the cursor.
The symbol and the number indicate the position of the
shutter.
SIMPLE BLIND: This command is used to open and close
the blinds. An additional command is used to set the angle
by pressing the
and
symbols.
The symbol indicates the position of the blind.
BLIND POSITION: This command is used to open, close
and set the position of the blinds.
By pressing the
and
symbols, you can set the
position of the blinds.
By pressing the
and
symbols, you can set the
angle of the blinds.
You can also make these settings by sliding your finger
over the cursor.
The symbol and the number indicate the position of the
blind.
2.1.3
Heating
This command is used to control the temperature throughout the home and to set it according to need at any given time.
It is also possible to control an air conditioning unit if installed. The device, depending on the type chosen, may be
presented in 2 forms:
HEATING: This command is used to set the 4 heating
modes (
,
,
,
) and the set point temperature
(
,
).
The symbol indicates the active heating mode. The first
number, at the bottom, indicates the temperature, the
second indicates the set point temperature, which may also
vary according to the mode chosen.
HEATING-AIR CONDITIONING: In addition to the
commands described above, you can control your air
conditioning unit with the help of the
and
symbols.
The symbol to the side indicates the operating status of the
air conditioning unit.
