732.28.424
HDE 26.07.21
10/12
en
4. Connect Mesh 4-Channel Interface Installation Guidelines
4.1. General Information:
•
Connect Mesh 4-Channel Interface has 4 Channels.
•
These 4 Channels can be used to control Luminaire/Häfele Devices connected in Connect Mesh 6 way
distributor.
•
Luminaire connected to Connect Mesh 6 way distributor are dimmable.
•
Connect Mesh 4-Channel Interface is battery driven (CR2430).
•
1–4-way Push Switch is compatible but Normal Switch is not compatible.
[image 7] Connect Mesh 4-Channel Interface – Hardware Version 2 (With Reset button)
4.2. Step-by-Step Procedure:
In this document, we explicitly provide step-by-step procedure to install a Connect Mesh 4-Channel Interface with
a GIRA Switch. In this case, we used GIRA 014700 4-way push switch as an example. You can also use any similar
type of 4 way push switch.
1. Power Supply:
Connect the Red wire in the GIRA Switch power supply slot as illustrated in image 8.
2. Bridge Wire:
The Black wire is used as Bridge between the two sides of the GIRA switch. One side of the Black wire is
connected next to Red Wire of the Interface (L) and other side is connected to another L as shown in image
9. The Purpose of this bridge wire is to low the current in both sides of the Switch.
[image 8]
[image 9]
Red wire (L) – Common
positive wire
Brown wire – Negative
wire for Channel 4
Green wire – Negative
wire for Channel 1
Blue wire – Negative
wire for Channel 2
Yellow wire – Negative
wire for Channel 3
