Hafco BS-460AS, Инструкция по эксплуатации

Страница: 6 / 30

D. Operation mode switch – selects either
automatic or manual operation mode.
2.8 Deactivation of machine
If the machine is to be out of use for a long period,
it is advisable to proceed as follows:
D1. Manual operation mode – press switch D until
the manual mode’s indicator light shows up. 1) Disconnect from the power supply
2) Loosen the tension on the blade
D2. Automatic operation mode – press switch D
until the automatic mode’s indicator light
shows up. 3) Release the bow return spring
4) Empty the coolant tank
5) Carefully clean and grease the machine
E. Bow up switch – press to raise the saw bow
6) If necessary, cover the machine. F. Vise open switch – press to open the vise
Dismantling (due to deterioration and/or
obsolescence)
G. Vise close switch – press to close the vise
H. Bow down switch – press to lower the saw
bow As a General Rule,
If the machine is to be permanently demolished
and/or
scrapped, divide the material to be
disposed of according to type and composition, as
follows:
I. Cycle start switch – press to begin operation
J. Stop switch – press to stop operation cycle
and return to start position
1) Cast iron or ferrous materials , composed of
metal alone, are secondary raw materials, so
they may be taken to an iron foundry for re-
smelting after having removed the contents
(classified in point 3).
2) Electrical components, including the cable and
electronic material (magnetic cards, etc.), fall
within the category of material classified as
being assimilated to urban waste according to
the laws of your local, state, or federal
government, so they may be set aside for
collection by the public
waste disposal service;
3) Old mineral and synthetic and/or mixed oils,
emulsified oils and greases are considered
hazardous or special refuse, so they must be
collected, transported and disposed of at a
special waste disposal service.
NOTE: The
standards and legislation concerning
refuse is in a constant state of evolution, therefore
is subject to changes. The user must keep
informed of the regulations at the time of disposal
as these may differ from those described above.
3 DESCRIPTION OF MACHINE PARTS
3.1 Control panel
K. Cutting feed rate – adjust the rate of cutting of
the saw bow.
L. Key lock power switch – to start or stop power.
L0. Power off switch – key switch to turn power
off
L1. Power on switch – key switch to turn power
on
M. Emergency Stop Button – Press to stop all
machine functions
N. Blade tracking switch – press to activate
blade tension and set the blade tracking.
O. Coolant start switch – press to activate or stop
coolant flow
P. Counter – counts the pieces cut, press the
button to reset units to zero.
Q. Stroke height switch – limits the stroke height
to eliminate the wasted motion and time.
Maximum height limit is 330mm.
3.2 Indicator lights
A. Main connect switch – main power
B. Main power indicator light – indicates that main
power is active
C. Hydraulic flow control start switch – actives
hydraulic power
1. Coolant pump warning light
2 Hydraulic pump warning light
3. Vise pressure warning light
4. Open blade cover warning light
5. Broken blade warning light
6. Main motor warning light
7. Lower stroke limit indicator light
8. Upper stroke limit indicator light
9. Emergency stop indicator light
6 Instruction Manual for BS-460AS (B035) 31/03/2016