Hafco BS-460AS, Инструкция по эксплуатации

Страница: 14 / 30

- Turn OFF the hydraulic pump.
- Attach the hydraulic hose to connecter (B) and
then attach the quick link connecter (J) to the
90-degree fitting.
- Switch ON the hydraulic pump.
6 OPERATION CYCLE
6.1 Operation cycle
6.2 Stopping or emergency stopping
There are two ways to stop the machine in an
event of an emergency or improper operation.
J
- For most situations, use the stop switch 6.1 J.
Using the stop switch 6.1 J will not reset the
controls and your operation setting. The blade
and drive motor will stop. Then the saw bow will
rise to the start position. Adjustments can be
made.
- Use the cycle start switch to continue the cutting
cycle.
- For unsafe and emergency conditions use the
emergency stop button 6.1 M. Using
emergency stop button 6.1 M will stop the
machine in last position. The motor and
hydraulic will stop and control setting will be
reset.
- To restart, the emergency stop button 6.1 M
must be turned to release from the pressed
position. Then the operation cycle 6.1 must
restarted.
6.3 Automatic shutoff during machine
operation
If there are any improper operation or situation,
the machine is designed to automatically shut off
during the operation cycle to prevent any further
damage from occurring.
- If the hydraulic pump is on and the machine has
not been active for 5 minutes, the power will be
shut off.
- If the time take to clamp the vise is over 40 sec,
the power will shut off. The vise pressure warning
light will flash in warning.
- After cutting the saw bow has taken more than
40 sec to rise to the start position, the power will
shut off. The upper stroke-limit indicator light will
flash in warning.
- Turn on the main connect switch A. on the door
of electrical box.
- Turn the key to automatic operation mode L1 to
unlock the machine. The indicator light B should
be lit.
- After pressing the start button, the vise clamps
the work piece, and saw bow begins cutting. If
the cutting time is unable to finish within 90
minutes, the lower stroke limit indicator will flash
in warning and the power will be shut off.
- Start the hydraulic system, use switch C.
- Press the selector D to manual operation mode
D1, and its indicator light will be lit.
- Raise the saw bow, Use bow up switch E.
If any of the above situations occurs, reset the
machine by pressing 6.1D. This will change the
operation mode – manual or automatic.
- Open the vise, use vise open switch F.
- Load the working material.
- Secure the material, use the vise close switch G.
- Base on the diameter of the material; set the
saw bow’s height Q.
- Choose the blade speed appropriate for the
material.
- If cutting many pieces, set the saw bow return
stroke height.
- Select the operation cycle mode 6.1 D2 to press
the selector 6.1 D. The indicator light will be lit.
- Restart the hydraulic system. Press the
hydraulic start switch 6.1 C. .
- Start operation by using the start switch 6.1 I.
- The digital display 6.1 P will present pieces cut.
- When the cutting operation is finished the saw
bow will automatically rise to the preset height
ready for the next operation.
14 Instruction Manual for BS-460AS (B035) 31/03/2016