Hafco BS-460AS, Инструкция по эксплуатации

Страница: 4 / 30

2 MACHINE TRANSPORTATION AND
INSTALLATION
2.1 Machine dimensions
2.2 Transporting the machine
2.3 Minimum requirements for housing the
machine
- Main voltage and frequency must comply with
the machine’s motor requirements.
- Environment temperature should fall within
(-10ºC to + 50 ºC).
- Relative humidity cannot be over 90%.
2.4 Installing the rear coolant return tray
The rear coolant-return tray must be installed after
the machine is set in place. Install the coolant
return trays first.
Installing three channeled L-bracket
Install three channeled L-bracket to the back of
the machine stand. Attaching the brackets
requires 6 hex head bolt, 6 spring washers, 6
washers, and 6 nuts.
Unpack your machine carefully, and use a crane
or forklift to set it in position. If a crane is used to
lift the machine, attach the lifting cable carefully to
the machine. Sufficient space should be left
around the machine to allow safe handling of
materials, inspection, and maintenance operations.
Take precautions to choose a location that will
keep the machine free of vibration and dust
caused by other machinery.
- Place a spring washer and washer on each hex
head bolt.
- Face the long side of the bracket up.
- Align the holes of short side of the bracket to the
machine panel’s holes.
- Place the 2 hex head bolts and their washers
through each bracket and machine panel.
- Use a nut on the inside of the machine stand to
secure each hex head bolt.
securing the rear tray
Attaching the trays requires 6 hex head bolt, 6
spring washers, 6 washers, and 6 nuts.
Bolt
point
- Arrange the tray rims to facing up and away
from the machine.
- Place the rear return tray onto brackets at the
back of the machine.
- Align the holes of the rear tray and the six-
channeled L-brackets.
- Place 6 hex head bolts through the holes of the
trays and brackets.
- Secure each hex head bolts with a washer,
spring washer, and hex nut.
4 Instruction Manual for BS-460AS (B035) 31/03/2016