Hafco BS-13LS, Инструкция по эксплуатации

Страница: 18 / 34

16
9-14. HOW TO USING CLEAN EQUIPMENT
After finished cutting, you can clean the chip by using clean
equipment.
Adjust the screw (A) (on the end of spray) to control the volume
of coolant fluid.
NOTICE : Please using the suitable volume of coolant fluid for
cleaning.
Cleaning the floor immediately when the coolant
fluid leaking on the floor.
Always keep the floor dry to prevent slip or any accident.
9-15.When the coolant is used and dirty
The cooling pump is almost entirely maintenance-free.
Replace the cooling agent regulary,depending on usage.
When using coolants which leave residues, the cooling pump be washed.
Pump the coolant to an adequate vessel by the spray gun.
Let the remenant coolant drain though the outlet.
Fill in new coolant over the chip pan. The maximum capacity of the coolant is 30 litres.
Coolant
10.MAINTAINING
That's easier to keep machine in good condition or best performance by means of maintaining it at any time
than remedy it after it is out of order.
(1) Daily Maintenance (by operator)
(a) Fill the lubricant before starting machine everyday.
(b) If the temperature of spindle caused over-heating or strange noise, stop machine immediately to cheek
it for keeping accurate performance.
(c) Keep work area clean; release vise, cutter, work-piece from table; switch off power source; take chip
or dust away from machine and follow instructions lubrication or coating rust proof oil before leaving.
(d) Please confirm no breaking in give bedspring or damaged cylinder tile road with leaking problems
before use.
(2) Weekly Maintenance
(a) Clean and coat the cross leading screw with oil.
(b) Check to see if sliding surface and turning parts lack of lubricant. If tile lubricant is insufficient, fill it.
(3) Monthly Maintenance
(a) Check if the fixed portion has been loose.
(b) Lubricate bearing worm, and worm shaft to avoid the wearing.
(4) Yearly Maintenance
(a) Adjust table to horizontal position for maintenance of accuracy.
(b) Check electric cord, plugs, switch, bedspring , Cylinder Assembly at least once a year to avoid
loosening or wearing.
A
Fig.21
18 Instruction Manual for BS-13LS (B031) 30/03/2016