Hafco BS-13LS, Инструкция по эксплуатации, Страница: 16 / 34

14
B D E Fig.17 C A
When change angle-cutting. Please follow bellow steps:
1.release the handle H (fig 15) and A (fig 16) to required angle and fix
the handles.
2 Release (A) (B) of Fig.14 adjust to required angle the fix it.
3 Place work-piece the top of it touch distance-rod.and set the length
you need.
4.Tighten vise jaw the fix the work-piece and get the same
cutting length.
9-11.REMOVING AND INSTALLING THE BLADE
When it is necessary to replace the blade, proceed as
follows:
1. Raise the saw frame about 6" and close the feed
on/off knob by turning it clockwise as far as it will
go (fig 17).
2. Move the blade guide arm to the right.(E)
3. Disconnect the machine from the power source.
Loosen cover screw, remove cover (A), open the
cover (B), remove cover (C) and (D), then clean
the chips and dirt inside the machine.
B A
Fig.14
A H
Fig.15
Fig.16
16 Instruction Manual for BS-13LS (B031) 30/03/2016