Hafco BS-13LS, Инструкция по эксплуатации

Страница: 12 / 34

10
Fig. 3
M K L J
9.USE OF MAIN MACHINE PARTS
9-1.POWER SYSTEM AND CONTROL PANEL
The electrical rating of your band saw is either with 230 volt-single phase, or 400 volt-3 phase, magnetic
control.
Before connecting your machine to an electrical power system, be sure the motor shaft is running in the
correct direction.
We recommend that 1.5mm² fused with a 10 amp, dual element, time lag fuse, to be used to supply power
to all machines regardless of their electrical rating.
Refer to the electrical wiring diagram supplied with your machine for instructions on how to connect saw
to power source. Power must be cut off when wheel cover is opened or during repairing.
Please check the moving direction of the blade. If the blade is moving in the wrong direction, please
re-connect the wire.
9-2.STARTING AND STOPPING MACHINE
1. Light (D) will be on when power is connected. Open hydraulic valve (H) when in
operation.
2. Push the button (C) for raising up the saw arm away from the saw table. If saw
arm can not be raised, please check if the power is properly wired.
3. Start the motor by pushing the start button (A), Turn left (G) to clean the chip by
using spray equipment. Turn right (G) to open the coolant system when
saw blade is running. When the cut is completed,
turn off the coolant system (G) in the middle.
4. Check if the upper limit switch is in proper position. Adjust handle (J) to move
the up-down position.
5. Push button (B) for controlling downwards of saw arm. And control the
downward speed by adjusting hydraulic volume valve.
6. When motor is running, push button (B), saw arm will automatically go down and start cutting the work
piece. When the cutting is finished, saw arm will rise up itself. The motor will stop
when saw arm touching the upper limit switch. Push button (F) to stop the machine, if
needed.
D C F E
G B A
H I
12 Instruction Manual for BS-13LS (B031) 30/03/2016