23
OPERATION MANUAL
To adjust the Zero (90°) stop.
1. DISCONNECT MACHINE FROM THE POWER SUPPLY
2. Make sure that the blade is oiled and tensioned,
tracking correctly, and the guides are set correctly
3. Raise the saw bow, then move the head and set the
scale to “0”. (Fig. 5.10) then lower the saw bow and lock
in place.
4. Check that the “0” head stop is hard up against the
stop pin. If there is a gap between the pin (Fig. 5.11)
and the stop screw, then loosen the lock nut and
adjust the stop bolt until it rests against the pin.
5. Tighten the lock nut on the swivel head bolt.
6. Unlock the head and swivel the head away from the
stop and the return and check that the adjustment is
correct.
7. Take a cut and check with a square.
To adjust the 45
°
angle stops.
1. DISCONNECT MACHINE FROM THE POWER SUPPLY
2. Make sure that the blade is oiled and tensioned,
tracking correctly, and the guides are set correctly
3. Raise the saw bow, then move the head and set the
scale to 45°. (Fig. 5.12) then lower the saw bow and
lock in place.
4. Check that the 45° head stop is hard up against the
casting. If there is a gap between the casting (Fig. 5.12)
and the stop screw, then loosen the lock nut and
adjust the stop bolt until it rests against the casting.
5. Tighten the lock nut on the swivel head bolt.
6. Unlock the head and swivel the head away from the
stop and the return and check that the adjustment is
correct.
NOTE:
The scale maynot be accurate and should only be
used as a guide.
7. Take a cut and check the angle with a square. If the
finished cut is not correct then loosen the lock nut and
adjust the stop acordingly. (Fig. 5.13)
.
45° Swivel Stop
F
ig
. 5.12
45° Swivel Stop
F
ig
. 5.11
90° Swivel Stop
F
ig
. 5.13
Page 23
Instruction Manual for EB-280DSV (B063V)
10/04/2019
