22
OPERATION MANUAL
5.6 ADJUSTING THE AUTO FEED STOP
During adjustment of the blade guides it may be neces-
sary to remove the feed auto stop for better access.
If this has happened then the feed auto stop needs to be
reset.
To adjust the feed auto stop.
Undo the lock nut on the feed auto stop bolt and adjust
the bolt so that the teeth on the band-saw blade are just
below the vice table surface when the blade has finished
the cut and the machine stops.
Feed Auto Stop
Before any blade adjustment is made it may be necessary to adjust the feed stop. The blade
should never rest or rub on any part of the vice casting.
The over tilt stop may also need to be adjusted to stop the saw bow from being able to lift past
40° causing the machine to be unstable.
5.5 ADJUSTING FEED STOPS
To Adjust the Feed Stop Bolt
1. DISCONNECT MACHINE FROM THE POWER SUPPLY
2. Release the lock nut on the Feed Stop bolt.(Fig.5.8)
3. Adjust the feed bolt until the teeth on the saw blade
are just below the vise table surface when the
machine stops.
4. Tighten the lock nut and run the machine cycle and
check that the adjustment is correct.
Head Swivel Scale
F
ig
. 5.10
5.7 ADJUSTING THE HEAD SWIVEL STOPS
The head swivel stops are set by the factory, but due to
shipping or continuing use, the stops may need to be
adjusted.
NOTE:
The scale is only to be used for approximate
guide. For accurate setting a protractor should be used
F
ig
. 5.8
Over Tilt Stop
Feed Stop
F
ig
. 5.9
Auto Feed
Stop
Page 22
Instruction Manual for EB-280DSV (B063V)
10/04/2019
