Haes ESEN-2MAR, Инструкция по установке, пусконаладке и эксплуатации

Страница: 16 / 44

Esento Marine 2-4 Installation, Commissioning & Operating Manual Approved Document UI-ESEN4MAR-01 Issue 6.0
14
SETUP & PROGRAMMING
LEVEL 3 ENGINEERING OPTIONS
- + - + - + - + - + -
SNDR1 SNDR2 ZONE1 ZONE2 ZONE3 ZONE4
1 2 3
ON
1 2 3
ON
A series of programmable engineering options are available. These
programming modes are initiated by entering a four digit code using
buttons 1 - 4 on the keypad followed by the ENTER button.
1 2 3
ON
1 2 3 4 5 6 7
1 1 1 3
Reset all disablements, test modes and parameters back to factory settings.
Options
Enter the above code and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds.
Any disablements or test mode settings will now clear and all
engineering option parameters will revert back to factory settings.
The panel will bleep to acknowledge the reset.
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
To access Level 3 options, first set switch 3 on the 3 way DIL switch located on the main PCB to the
‘ON’ position. Then activate the controls by entering the four digit code (see Activate Controls in the
OPERATING section).
The ‘Access Level’ indicator will pulse
rapidly to signify that Level 3 access is
active.
2 2 2 4
Set fault buzzer volume.
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
There are two levels of volume for the internal fault buzzer, high and low.
Enter the above code and press the ENTER button to increase or decrease
the fault buzzer tone from the previous level.
Setting will change when ENTER button is pressed.
When finished, enter the next programming code or disable the controls and return DIL switch 3 to ‘OFF’.