USER INSTRUCTIONS
RESOUND
SILENCE
RESET
ENTER
1
2
3
4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
RESOUND
SILENCE
RESET
ENTER
1
2
3
4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
RESOUND
SILENCE
RESET
ENTER
1
2
3
4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
If an alarm condition is present YOU MUST FOLLOW YOUR NORMAL FIRE DRILL PROCEDURES.
A responsible person should then:-
1.
1.
Check the control panel to see which area or zone has caused the system to go into alarm. This
Check the control panel to see which area or zone has caused the system to go into alarm. This
will be indicated by a pulsing red LED on the front of the control panel.
will be indicated by a pulsing red LED on the front of the control panel.
2.
2.
Go to the area which has caused the alarm to check if a
fi
re exists.
Go to the area which has caused the alarm to check if a
fi
re exists.
3.
3.
Only when it is safe to do so should the alarms be silenced. Activate the controls by turning the
Only when it is safe to do so should the alarms be silenced. Activate the controls by turning the
key switch or by entering the four digit code (see Activate Controls in the OPERATING section)
key switch or by entering the four digit code (see Activate Controls in the OPERATING section)
and press the (blue) SILENCE ALARMS button (
fi
g 1). To sound the alarms again press the (red)
and press the (blue) SILENCE ALARMS button (
fi
g 1). To sound the alarms again press the (red)
RESOUND button (
fi
g 2).
RESOUND button (
fi
g 2).
4.
4.
In the event of a false alarm look for the device that has caused the alarm. A detector will have a
In the event of a false alarm look for the device that has caused the alarm. A detector will have a
red LED lit, or check to see if a call point glass is broken (if so replace the glass or call an engineer).
red LED lit, or check to see if a call point glass is broken (if so replace the glass or call an engineer).
5.
5.
When fully satis
fi
ed that there is no
fi
re, return to the control panel and press the (green) RESET
When fully satis
fi
ed that there is no
fi
re, return to the control panel and press the (green) RESET
button, (
fi
g 3). The panel display should return to normal and only the green SUPPLY HEALTHY
button, (
fi
g 3). The panel display should return to normal and only the green SUPPLY HEALTHY
LED should be lit on the control panel.
LED should be lit on the control panel.
fi g 1
fi g 2
fi g 3
If the system continues to false alarm, call an engineer
If the system continues to false alarm, call an engineer
Fault Condition
Fault Condition
If a buzzer is sounding in the control panel but the sounders or bells are not ringing, then there is either a
If a buzzer is sounding in the control panel but the sounders or bells are not ringing, then there is either a
fault on the system, or zones / sounders have been disabled. CALL AN ENGINEER
fault on the system, or zones / sounders have been disabled. CALL AN ENGINEER
The internal fault buzzer can be silenced by pressing MUTE BUZZER (button 3 on the keypad). DO
The internal fault buzzer can be silenced by pressing MUTE BUZZER (button 3 on the keypad). DO
NOT RESET THE SYSTEM UNTIL AN ENGINEER HAS INVESTIGATED THE FAULT.
NOT RESET THE SYSTEM UNTIL AN ENGINEER HAS INVESTIGATED THE FAULT.
Tear Her
e
www.acornfiresecurity.com
www.acornfiresecurity.com
