5.52.179.00.01.09
21
12.5.2
Mechanical spring assembly
In case of overload the load must be lowered until it reaches the ground so that the
spring assembly can release. Only thereafter it is possible to repeat the lifting motion.
Illustration 14
Illustration 15
12.5.3
Electronic hoisting power limiter (as option, except serial AT)
Power consumption of the hoist motor is measured during lifting movement of a load
by an adjustable power measuring device (overload guard). The setting is made via a
separate relay for main and creep lifting speed. Power consumption of the motor is
load-dependent and increases with the load. If the set value is exceeded, the relay
responds immediately and switches the motor off via switching elements. After the
overload protection has been activated the LOWER button must be pressed first so
that the LIFT function can be activated again. Before lifting again the load must be
reduced to the nominal load!
Illustration 16
12.6
Stretch the roller chain.
Only applicable for hoists acc. to table 2
Tension of the roller chain must be checked and
adjusted if necessary.
For correct adjustment there is a mark on the
tension device (B).
Illustration 17
Procedure:
Hold tension device (B) with the wrench SW
36.
Release screw (A) with wrench SW 17.
Turn tension device (B) until the edge (◄) of
the tension lever (C) fits precisely with the (►)
15° mark (►◄).
Tighten screw (A) again.
Illustration 18
13
Inspection
13.1
General Overhaul for motor-driven units
The validated, national accident prevention regulations must be observed and the measures to reach "safe
working periods (S.W.P.)" according to FEM 9.755.
After the "theoretical working time D" has been elapsed, the owner/user must take motor driven devices out
of operation and effect a General Overhaul.
Further use of the equipment is only allowed after a licensed qualified person has proofed
that further use is possible without doubt
and
the conditions for further use have been determined
These conditions have to be written down in the test book.
The owner/user is responsible to make sure that these conditions are observed.
