Hacker JETIBOX, Руководство пользователя

Страница: 18 / 20

18
Manual JetiBox
How do I connect a motor
(three black cables) to the
Speed Controller (blue, red,
and yellow cable)?
Simply connect one black cable to one coloured cable. If the motor turns in
the wrong direction, just swap any two of the three cables. Additionally the
rotation can be changed by programming with the JetiBox for all MasterSpin
Controllers.
Do I need a JetiBox to set the
controller for Li-Io / LiPo bat-
tery use?
Basicly, you can set one of six modes with your transmitter. In all of these
modes there is LiPo-Cut Off enabled. This is a LiPo-Autodetect with a slow
down on 3,0V/cell.
Please Note!
LiPo-Autodetect only works correct if LiPo-Pack is fully charged when
conected!
For further LiPo-Setup, please use JetiBox!
Which Speed Controller ti-
ming is best for my motor?
Timing 0..4°:
Hacker-Brushless Motor Series B-20, B-40 and B-50, as well as C-40 and C-50
Motors and all other 2-pole Innrunner.
Timing 0..10°:
4-pole Inrunner
Timing 5..18°:
6-pole to 8-pole Innrunner
Timing 24°:
For Motorseries A-20 to A200, as well as other 10-pole to 14-pole outrunner
motors.
Timing 24..30°:
14-pole and more. Please check the manual of your motor!
With the JetiBox the timing can be changed in 1° steps (from 0° to 30°). This
allows fine tuning for „special cases“.
My motor has no brake any
more. Is my motor dama-
ged?
No. In most cases it‘s not the motor‘s fault. Most probably the Speed Control-
ler is set to other mode by accident. This can happen if the controller is started
up while the throttle stick is in „full power“ position. Please check if can hear
only one „Beep“ after start up of the Speed Controller. In case you hear two
„Beeps“ change the mode to your prefered mode.
My motor doesn‘t turn and
only wobbles. Is my motor
damaged?
Most probably not. In most cases this behaviour is caused by a bad connection
between the Speed Controller and the motor. Check all connections. Change
the connectors or re-solder bad connections if necessary. In some cases the
cables are only hold in place by hear shrink tube. Bad connections cause an
increased transition resistance. This may cause a loss of power, a not properly
turning motor, up to complete destruction of the power stage.
I can‘t program my Speed
Controller with the JetiBox.
What do I make wrong?
Please check first if your Speed controller is featured with the necessary soft-
ware. You must read the word
MasterSpin
on the lable. The older MASTER
Speed Controller series with label MASTER xx-3P or MASTER xx-Flight or Heli
(xx stand for the operating current version) can not be programmed with the
JetiBox. The software of a Speed Controller can not be updated.
Please make sure the JetiBox is properly connected.
12. FAQ (Frequently Asked Questions)