Hacker JETIBOX, Руководство пользователя

Страница: 19 / 20

19
Manual JetiBox
How do I connect the Jeti-
Box for programming to the
Speed Controller?
Connect the JetiBox to the Speed Controller.
The motor must not be connected . If you connect a motor, do not mount the
propeller or pinion to avoid injuries by rotating parts.
At last connect the power battery. Without power battery the controller can‘t
receive the programming commands.
My motor doesn‘t „Beep“ if
I connect a battery to the
Speed Controller!
Pleas check the following points:
• Is the Speed controller properly connected according to this manual?
• Is your speed controller in good order and condition (no mechanical
or electrical damages visual)?
• Is the BEC switch turned on (only for versions with BEC)
• Is the receiver power turned on?
• Is the receiver battery fully charged, properly connected and swit-
ched on (position ON / EIN)?
• In case the „motor stop“ position is programmes to a fixed pulse va-
lue, the throttle stick and trim must be in the according position. The Speed
Controller is only activated it the throttle stick is in the proper „motor stop“
position when started up.
• Is the power battery fully charged? If a cutoff voltage is programmed,
the voltage of the power battery must exceed the cutoff voltage.
My motor is not running un-
til „1/3 throttle“ position and
the speed can‘t be comman-
ded sensitive.
Most probably the throttle stick ATV adjustment is not set to 100% for both
side or the throttle stick is not in the proper „motor stop“ position when the
Speed Controller is started up. In mode automatic initial point the Speed Con-
troller may assume a higher throttle stick position as „motor stop“ position.
This reduces the usable throttle stick resolution. As result the Speed control-
ler can‘t be commanded fully sensitive.
To adjust the correct throttle stick throw disconnect the power battery. Please
make sure your ATV adjustment is set to 100% for both side, your throttle
stick is in the proper motor stop position and the trim is in neutral position.
Than re-connect the power battery. The Speed Controller initial point will be
new adjusted (if automatic mode is set).
Can I dump the stored set-
tings of a Speed Controller
to a Prog-Box?
Yes! The JetiBox works like a Display and Keyboard.
Where can I get help if I have
further questions not exp-
lained in the manual?
Ask the authorised dealer where you bought your Speed Controller
Look for further information on our homepage
www.hacker-motor.com
Send an email to: service@hacker-motor.com
Call our service via phoner: +49-8761-752 129
1.
2.
3.
4.
Is it possible to run two or
more motors on only one
Controller?
No! Only one motor can be used with one Speedcontroller!
If you have only one batterypack, you can connect both ESCs parallel.
If you use more batterypacks, all packs must be connected parallel!
If you use BEC-Typ ESCs, only ONE BEC can be used. All others must be swit-
ched of!