ADJUSTMENT OF LEFT MAIN LANDING GEAR AND SWITCH
When the left main landing gear assembled in Stage 28 is pulled out from the base, it may not be
perpendicular to the ground. In addition, the left main landing gear switch installed in Stage 33 may not
be completely pressed. Both may be adjusted with the parts in this stage as follows...
You will also need: screwdriver, tweezers.
Left main landing gear switch key
STEP 1
Adjusting the angle of the left main landing gear
STEP 2
1
2
3
4
5
1
2
3
4
5
NOTE
The two screws that secure the left
main landing gear are different sizes,
so be careful not to make a mistake
when reattaching.
Remove the four screws that secure the
left main landing gear motor cover
032-01
and remove the cover.
Remove the two screws that secure the
left main landing gear and remove it.
Remove the two screws fixing the left
main landing gear switch
033-03
, and
then gently lift up the switch to reveal the
holes underneath.
Place the washer
041-11
over the right
screw hole. Replace the switch, carefully
sandwiching the washer in place.
Re-fix the left main landing gear switch
033-03
with the two screws taking care
not to shift the washer.
Remove the backing from liner
041-12
using tweezers.
Attach the liner
041-12
to the shock absorber
028-01
in the
position shown and then replace the metal fittings removed in 1.
Fit the landing gear into its original position on the frame. If it
isn’t fitting correctly, remove the gear
032-03
and shaft
032-05
,
then fit the landing gear again before returning
032-03/032-05
to
its position, pressing the shaft to ensure it comes into contact
with the switch.
Hold the left main landing gear so that it doesn’t float, and fix it
with the two screws. Be careful not to make a mistake, as the
front is a thin screw and the back is a thick screw.
Taking the main landing gear
removed in STEP 1, remove the
metal fittings of the cover on
both sides.
Thin screw
Thick screw
Thin screw
Thick screw
041-12
041-12
028-01
028-06
033-03
032-03
032-05
組み立てガイド
組み立てガイド
21
AGORA
MODELS