User Guide
TGT. 25.06.2019
Technical
Page 6 of 20
©Copyright by Habegger Maschinenfabrik AG
Version 04 / 25.06.2019
1
General specifications
The motor-driven rope pulling machine HIT-TRAC 8 is designed for pulling, hoisting and lowering loads.
1.1
Drive mechanism
A special HABEGGER steel rope of desired length, which is guided over the relevant guide elements by the driving wheel and
then ejected in an unloaded state, is used as the drive mechanism.
1.2
Housing cover
The removable cover on the driving wheel prevents the entry of foreign objects and protects against accidents resulting from
improper access. There is also an anti-derailment device for the traction rope integrated into the housing cover.
-
Always close and lock the housing cover over the driving system before operation.
1.3
Rope
In the factory, the machine is preconfigured to use ropes with diameters of 8.2 mm.
This rope is suitable for all hoisting, pulling and lowering work.
-
Only suitable, original HABEGGER ropes should be used.
1.4
Operation
The machine operates on an alternating current of 230 volts using a transformer and a three-phase rotary current motor
1.5
Electrical control system
On / off control system
The control system is located, alongside the transformer, in the control box on the motor.
The input comes from the mains plug via a 5m long supply cable.
Also connected to the control box, via a 3m long control cable, is a pendant station with the control buttons UP/DOWN, the
emergency stop button, and a rotating knob to control the speed.
