Haas Door 610, Руководство по эксплуатации и техническому обслуживанию

Страница: 7 / 14

Haas Door Commercial Instruction Manual
2 © 2015 Haas Door Company Rev. 7/15
B
Some large doors
may require additional
pad or pads located off
center to accommodate
auxiliary bearings.
STEP 1 INSTALLATION OF DOOR
Check the size of door to be sure it is the same size as opening. Inspect the track and determine if you have reverse angle or
bracket mount tracks. Note: bracket mount has individual j-brackets to attach track to jamb, reverse angle has a continuous
angle to attach track to jamb. Note: if door is supplied with reverse angle. The door should be 2” wider than opening.
STEP 2
Attach hardware to bottom section with 1/4” x 3/4” hex head sheet metal screws (see Figure 3). If door requires struts, see
Figure 8 on page 4.
All vertical jambs
and pads regardless
of type, must extend
to top of headroom
requirement.
S
S
W
W
2 X 6
Wood Jambs
Section “W”
Steel Jambs
Section “S”
Steel
Channel
3” Min.
W W S S
Opening Width
Interior Elevation
Opening Height
Note : All framing materials must be provided
by building contractor or installer.
Figure 2
J
G
H
Bottom
Section
Center
Hinge
End Hinge
see Figure 6
on page 4
for correct
hinge numbers
Roller
Cable
Bottom Bracket
Drill a 3 /16” diameter
hole for this screw
Figure 3
Weatherstrip
Center Stile
OPENING PREPARATION