H3C UniServer R6700 G3, Руководство пользователя

Страница: 44 / 151

6-11
6.
Remove the SATA M.2 SSD. Remove the screw that secures the SSD on the transfer module
and then pull the SSD out of the connector.
Installing a SATA M.2 SSD
1.
Install the SATA M.2 SSD to the M.2 transfer module. Insert the connector of the SSD into the
socket and then use the screw to secure the SSD into place.
2.
Install the transfer module to a riser card. Insert the PCIe module into the slot along the guide
rails and use the screw to secure it into place.
3.
Install the riser card to the server:
a.
Install the riser card on the PCIe riser connector.
b.
Connect the SATA M.2 SSD cable. For more information, see " Connecting the SATA M.2
SSD cable ."
4.
Install the access panel. Place the access panel on top of the server chassis and slide the
access panel toward the server front until it snaps into place.
5.
Rack-mount the server. For more information, see " Rack-mounting the server ."
6.
Connect the power cord. For more information, see " Connecting the power cord ."
7.
Power on the server. For more information, see " Powering on the server ."
Replacing the M.2 transfer module
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Removing the M.2 transfer module
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. Pressing the two unlock buttons on the access panel, slide the panel
toward the server rear, and then lift the panel to remove it.
4.
Remove the riser card that has a M.2 transfer module attached:
a.
Disconnect the SATA M.2 SSD cable from the M.2 transfer module.
b.
Lift the riser card out of the chassis.
5.
Disconnect the SATA M.2 SSD cable from the system board.
6.
Remove the M.2 transfer module from the riser card. Remove the screw that secures the M.2
transfer module and then pull the module out of the slot.
7.
Remove the SATA M.2 SSDs. Remove the screw that secures the SSDs on the transfer module
and then pull the SSDs out of the connector.
Installing the M.2 transfer module
1.
Install two threaded studs into place. Move the threaded studs from the screw holes that are far
away from the SATA M.2 SSD connectors on the transfer module to the screw holes closer to
the connectors.
2.
Install the SATA M.2 SSDs to the M.2 transfer module. Insert the connector of each SSD into
the socket and then use a screw to secure the SSD onto the threaded stud.