4-3
Figure4-4 Removing an NSQM1GP8A
(1) Loosen the captive screws
(2) Open the ejector levers
(3) Pull the module out of the slot
Replacing a hard disk
CAUTION:
•
To avoid storage medium damage, execute the
umount
command from the CLI to unmount all
the file systems before removing a drive.
•
Do not hot swap drives.
To replace a hard disk
1.
Log in to the Web interface. Click the
Unmount
button on the
Storage settings
page.
2.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
3.
Press the red button on the drive panel to release the locking lever.
4.
Hold the locking lever and pull the drive out of the slot.
5.
Install a new drive. For the installation procedure, see "
Figure4-5 Removing a drive
1
3
2
2
1
2
1
3
