H3C S7508E-X, Руководство по установке

Страница: 37 / 111

29
Prepare an IRF member ID assignment scheme. An IRF fabric uses member IDs to uniquely identify and
manage its members, and you must assign each IRF member switch a unique member ID.
Planning IRF topology and connections
Connect the IRF member switches through IRF ports, the logical interfaces for the connections between
IRF member switches. Each IRF member switch has two IRF ports: IRF-port 1 and IRF-port 2. To use an IRF
port, you must bind at least one physical port to it.
When connecting two neighboring IRF member switches, you must connect the physical ports of IRF-port
1 on one switch to the physical ports of IRF-port 2 on the other switch.
A two-member IRF fabric must use the daisy chain topology.
If the system software version you are using supports more than two IRF members, you can create an IRF
fabric that comprises more than two members in daisy chain topology, or more reliably, ring topology.
In ring topology, the failure of one IRF link does not cause the IRF fabric to split as in daisy chain topology.
Rather, the IRF fabric changes to a daisy chain topology without interrupting network services.
Identifying physical IRF ports on the member switches
Identify the physical IRF ports on the member switches according to your topology and connection
scheme.
On S7508E-X switch, only 10-GE/40-GE ports can be used for IRF connection.
The S7508E-X switch support multi-card link aggregation for IRF ports. You can bind up to eight physical
ports to one IRF port.
Installing IRF member switches
Step Reference
1. Prepare the installation site.
Chapter "Preparing for installation"
2. Mount the IRF member switches to racks.
Chapter "Installing the switch"
3. Install transceiver modules on IRF member switches.
Chapter "Installing FRUs"
Configuring basic IRF settings
After you install the IRF member switches, power on the switches, and log in to each IRF member switch
(see "Connecting your switch to the network") to configure their member IDs, member priorities, and IRF
port bindings.
Follow these guidelines when you configure the switches:
•
You may need to first change the operating mode of the switches to IRF mode depending on your
software release.
• Assign the master switch higher member priority than any other switch.
•
Bind physical ports to IRF port 1 on one switch and to IRF port 2 on the other switch. You perform
IRF port binding before or after connecting IRF physical ports depending on the software release.