H3C S5500-SI Series, Руководство по эксплуатации

Страница: 124 / 1217

1-13
Displaying and Maintaining LLDP
To do… Use the command… Remarks
Display the global LLDP
information or the information
contained in the LLDP TLVs to
be sent through a port
display lldp local-information
[ global | interface interface-type
interface-number ]
Available in any view
Display the information
contained in the LLDP TLVs
sent from neighboring devices
display lldp neighbor-information [ brief
| interface interface-type interface-number
[ brief ] | list [ system-name
system-name ] ]
Available in any view
Display LLDP statistics
display lldp statistics [ global |
interface interface-type
interface-number
]
Available in any view
Display LLDP status of a port
display lldp status [ interface
interface-type interface-number ]
Available in any view
Display types of advertisable
optional LLDP TLVs display lldp tlv-config [ interface
interface-type interface-number ]
Available in any view
LLDP Configuration Examples
Basic LLDP Configuration Example
Network requirements
As shown in Figure 1-4 , the NMS and Switch A are located in the same Ethernet. An MED device and
Switch B are connected to GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 of Switch A.
Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B
and the link between Switch A and the MED device on the NMS.
Figure 1-4 Network diagram for basic LLDP configuration
Configuration procedure
1) Configure Switch A.
# Enable LLDP globally.
<SwitchA> system-view
[SwitchA] lldp enable
# Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 (you can skip this step because
LLDP is enabled on ports by default), and set the LLDP operating mode to Rx.