H3C S3100 Series, Руководство по эксплуатации

Страница: 798 / 1057

1-11
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging , terminal logging , or terminal trapping command.
Setting to Output System Information to a Log Host
Table 1-12 Set to output system information to a log host
Operation Command Description
Enter system view system-view —
Enable the information center info-center enable
Optional
Enabled by default.
Enable system information
output to a log host
info-center loghost host - ip - addr
[ channel { channel - number |
channel - name } | facility
local - number ]*
Required
By default, the switch does not output
information to the log host.
After you configure the switch to
output information to the log host, the
switch uses information channel 2 by
default.
Configure the source interface
through which log information
is sent to the log host
info-center loghost source
interface-type interface-number
Optional
By default, no source interface is
configured, and the system
automatically selects an interface as
the source interface.
Configure the output rules of
system information
info - center source { modu - name |
default } channel
{ channel - number | channel - name }
[ { log | trap | debug } { level
severity | state state } ]*
Optional
Refer to Table 1-8 for the default
output rules of system information.
Set the format of the time
stamp to be sent to the log host info-center timestamp loghost
{ date | no-year-date | none }
Optional
By default, the time stamp format of
the information output to the log host
is
date .
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.