5
WARNING!
After you place the device on the slide rails installed on the rack, do not leave go of your hands
immediately because this might tip the device, damaging the device or even causing bodily
injury.
4.
Use M6 screws provided with the device to secure the mounting brackets to the rack posts.
As a best practice, use a torque of 30 kgf-cm (2.94 Nm) to fasten the M6 screws.
If the mounting holes in the mounting brackets cannot align with the cage nuts on the rack,
verify the following items:
The bottom edge of the slide rail aligns with the middle of the narrower metal area between
holes.
The cage nuts are installed in the correct holes.
Figure 2-3 Mounting the device in the rack
(1) Chassis handle
(2) Slide the chassis into the rack
(3) Use screws to secure the mounting brackets to the rack
Grounding the device
CAUTION:
•
Reliably grounding the device is crucial to lightning protection and EMI protection. Ground the
device reliably before you use it.
•
To guarantee the grounding effect, use the grounding cable (yellow-green grounding cable)
provided with the device.
•
Connect the grounding cable to the grounding strip in the equipment room or the grounding
point on the rack. Do not connect it to a fire main or lightning rod.
