24
Installing a transceiver module
The transceiver modules are hot swappable.
To install a transceiver module:
1.
Unpack the transceiver module.
Do not touch the golden plating of the transceiver module.
2.
Pivot the clasp of the module up. Holding the transceiver module, gently push the transceiver
module into the slot until it has firm contact with the slot, as shown in
Figure 3-24 Installing a transceiver module
NOTE:
The types of transceiver modules supported by the device might change over time. For information
about installing a transceiver module, see
H3C Transceiver Modules and Network Cables
Installation Guide
.
Connecting a cable
CAUTION:
When you connect a cable, make sure the bend radius of the cable is no less than eight times the
cable diameter.
The cables are hot swappable.
To connect a cable:
1.
Unpack the cable.
2.
Correctly orient the cable connector and gently insert the connector into the target port. To be
sure that the connector is seated securely in the port.
Transceiver modules and fiber ports have disorientation rejection designs. If you cannot insert
a transceiver module easily into a port, the orientation might be wrong. Remove and reorient
the transceiver module.
