Installation Manual
H3C S5600 Series Ethernet Switches
Chapter 3 Installing the Switch
3-17
Caution:
Read the mark for the port to be connected carefully to make sure it is the right port.
Note:
The serial ports on PCs do not support hot swapping. Therefore, do not insert or
remove a serial interface cable from a PC that is connected to a switch with power. In
connecting a PC to the switch, first connect the DB-9 connector of the console cable to
the PC and then the RJ45 connector to the switch. In disconnecting them, remove the
RJ-45 connector prior to the DB-9 connector.
3.6 Installing/Removing the Stack Cable
3.6.1 Stack Cable
To stack S5600 series switches, you need to use stack cables to connect the Fabric
ports of switches.
Figure 3-24
Diagram for stack cable
The stack cable for the S5600 series switch can be 0.65 m (2.1 ft.), 1.2 m (3.9 ft) and 5
m (16.4 ft) long. You can choose them according to your need.
3.6.2 Installing the Stack Cable
Step 1: Before you take the cable out of the package, wear an ESD wrist strip and make
sure it is well grounded.
Step 2: Insert the cable plug into the switch Fabric port flatly.
Step 3: Use a Phillips screwdriver or power screwdriver to fasten the captive screws at
both sides.