H2X THERAPOOL SE, Руководство пользователя

Страница: 30 / 108

28 DO NOT DIVE.
Regular Maintenance Procedures
102 DO NOT DIVE.
NOTE: These maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
CARE OF YOUR FILTER ELEMENTS
• The filter elements are one of the most important components of your swim spa. Not only are
they essential for clean water, but they also extend the life of the swim spa equipment. Your fil-
ter elements should be cleaned on a regular basis, at least once a month on average with normal
usage. With heavy use, poor water quality and/or high dissolved solid content in water; the filters
may need to be cleaned more often.
• Remember to turn off the swim spa before servicing filters. Never leave to the swim spa running
when removing the filters. Debris can be pulled into the plumbing system and cause unwar-
ranted damage.
• Periodically in between monthly cleaning, spray each standard or outer filter element with a
garden hose to help remove buildup from filter media surface. Monthly, the standard or outer
filter elements should be soaked in a filter cleaner. Check with your local Master Spas dealer for
details on cleaning and/or filter replacement recommendations. Do not soak the
EcoPur filter cartridge in any cleaners.
FILTER CLEANING
NOTE:
Never operate the swim spa without the filters installed. Damage to the pumps and other
components could result from operation without filters installed.
NOTE: Do not soak the EcoPur filter in a filter cartridge cleaner. Rinse off only.
1. Turn power off to the swim spa.
2.
Remove any large or floating debris from the filter area. Slide filter face plate up and out slowly.
For the H2X Therapool models, remove filter lid located on top of filter weir to access filters and
skip to step 6. All other models move to step 3.
3.
Allow the weir door to fall back towards the filters in order to remove the filter housing.
4. Lift up on the plastic housing and the entire housing will pop out.
NOTE: When lifting the housing, be careful not to lift too far, as you could break the floating weir
door. Damage to weir door is not warranted.
5.
Pull the plastic skimmer plate out from the filter housing in order to gain access to the filters.
6.
Unscrew the filter cartridges and remove for cleaning.
7. The filters should be rinsed off and the non-EcoPur filter(s) (outer if two piece EcoPour combina-
tion) should be soaked in a cartridge cleaner. Follow applicable cartridge cleaner instructions.
8.
Re-install filters and replace weir housing or filter lid, letting flap of housing fall back prior to slid-
ing housing back down.
NOTE: Eco-Pur filters should be replaced every 6 months. Non Eco-Pur filters should be replaced
every 12 months or as necessary depending on water quality, filter maintenance and bather
load.
•