4. Wipe inside of Head Assembly Dome and the Rubber Ring Seal to
remove any moisture or residue. Do not remove the Ring Seal in order
to clean and dry it. Simple wipe it with a clean towel.
5. Rinse out the inside of the Boiling Chamber and use a sponge
(Scotch-Brite™ or similar NON-METAL pads may also be used), to
remove any left over residue from the inside bottom, and rinse again.
Never submerge the unit in water.
(Try to keep the outside of the unit
dry while cleaning.) If scale remains, pour in approx. one-half cup of
plain white distilled vinegar and let set for an hour or so as needed and
then loosen with a sponge, (or Scotch-Brite™, etc.), and rinse out.
Difficult residue may require periodic use of a safe water scale cleaner
such as that supplied with the unit or available at H2oLabs.co.uk.
6. Fill the unit after cleaning in order to prepare for the next cycle.
7. Place unit on the counter-top and dry the exterior with a soft cloth
after each cleaning and filling to prevent water or rust spots. Also insure
that the Fan Plug and both outlet sockets on the Main Body are dry.
8. Position Head on the Body and
plug the Fan Cord firmly until it
has completely seated
into
it’s outlet on the unit. Plug the Main Power
Cord into the unit and then into the household outlet. Position Carafe
and press the Reset Button when you are ready to begin the next cycle.
MAINTENANCE
Never use abrasive cleaners, wire brushes or metal scouring pads which
can damage the surface of the Boiling Chamber or the exterior.
However, Scotch-Brite™ or similar NON-METAL pads may be used
for the INTERIOR surface.
The Boiling Chamber has normal “welding spots” at the bottom that are
sometimes visible. You should not attempt to remove them.
To maintain maximum efficiency, whenever heavy dust accumulation is
apparent on the condensing coil in the top of the unit, vacuum or blow
out with air pressure, through the slots in the cover.
- 13 -
