3. INSTALLATION
3-
3.8. CHECK POWER WIRES CONNECTION
1.
After the power wires have been connected it is necessary to check if the power
wires are connected to the correct connection points.
2.
Press the power switch on the control panel.
3.
Press the upper planing table raise switch (A) then the upper planing table (B)
should move upward. If not, any two of the three power wires"L1, L2, L3" inside the
control box need to be changed.
3.9. CONNECT DUST COLLECTION SYSTEM
1.
There are two dust hoods provided on the machine for sucking dust from upper and
lower cutterhead.
2.
Fit the flexible hose to the two dust hoods and connect them to the dust collector.
3.
The outlet diameter for each dust hood is 125mm.
Do not perform cutting operations until the dust collection system is started.
