3
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue
Low setting
SILICON
EPOXY A
EPOXY B
CA
GLUE
Epoxy Glue ( 5 minute type)
Silicon sealer
Cyanoacrylate Glue
.60 ~.70 - 4 cycle
10.5x6 for .40 - 2 cycle engine
11x6 for .46 - 2 cycle engine
12x6 for .60 - 4 cycle engine
12x7 for .70 - 4 cycle engine
Silicone tube
.46 ~ .50 - 2 cycle
Epoxy Glue (30 minute type)
TOOLS REQUIRED
Phillip screw driver
Awl
Scissors
Wire cutters
(Purchase separately)
Hex wrench
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
.........................................................
Hobby knife
Needle nose pliers
Sander
Masking tape - Straight Edged Ruler - Pen or pencil - Rubbing alcohol - Drill and Assorted Drill Bits
Symbols used throughout this instruction manual, comprise:
(Purchase separately)
Minimum
6
channel radio
for
airplane with
6-7
servos
.Motor control x1
or ESC,
Elevator
x1
.Rudder x1. Aileron x2
5055-430
Brushless Motor
or equivalent.
60
-80
amp Brushless
Speed Controller
Li-Po Battery, 6S 4000mAH
Read through the manual before you begin, so you will have an overall idea of what to do.
CONVERSION TABLE
1.0mm = 3/64”
1.5mm = 1/16”
2.0mm = 5/64”
2.5mm = 3/32”
3.0mm = 1/8”
4.0mm = 5/32”
5.0mm = 13/64”
6.0mm = 15/64”
10mm = 13/32”
12mm = 15/32”
15mm = 19/32”
20mm = 51/64”
25mm = 1”
30mm = 1-3/16”
45mm = 1-51/64”
If exposed to direct sunlight and/or heat, wrinkles can appear. Storing the
model in a cool place will help make the wrinkles disappear. Otherwise, remove
any wrinkles in the covering film with a hair dryer, starting with
low temperature. You can seal the edges by using a hot iron.
REQUIRED FOR OPERATION (Purchase separately)
15x6 if using a 5055-430 brushless motor.
2 x extension leads
for the aileron
servos. 1 x
extension if doing
the I.C. version for
the battery pack.
Содержание P 15B Mustang Berlin Express
Страница 1: ...INSTRUCTION MANUAL...