H-KING P 15B Mustang Berlin Express, Инструкция по эксплуатации, Страница: 11 / 15

5 5
BOTTOM VIEW
3/8 in. (9.5mm)
Apply a thin layer of machine oil or petroleum jelly to only
the pivot point of the hinges on one elevator. Then push
the elevator and its hinges into the hinge slots in the trailing
edge of the horizontal stabilizer. Ensure you leave just a
minimal gap to avoid binding of the hinge.
When satisfied with the gap and alignment remove and
apply 5 minute epoxy the elevator hinges. Make sure to
apply a thin layer of epoxy to the top and bottom of the
hinges and to inside the hinge slots Slide the elevator
hinges back into the slots in the stabilizer leaving the small
gap as above. Repeat this process for the other elevator.
Hinge
Petroleum jelly
STABILIZER
Control horn
................3
2x12mm screw
..........6
A B
Apply 5 min.
Epoxy to both the
top and bottom.
CA
6- Attach the tail wheel doors (D) in using CA glue.
1
3
4
5
2
5/64 in.(2mm) I.D collar
2x10mm
screw
...............1
Tailwheel wire
..........1
............1
2x3mm screw
............4
2x10mm screw
.................1
Tailwheel control-
horn
2mm I.D collar
6
1- Insert the tailwheel pushrod into the hole in the tailwheel control
horn as shown.
2- Install the tailwheel control horn to the tailwheel wire.
3- Install the tailwheel assembly as shown.
4-
5-
Secure the tailwheel control horn to the wire using a 5/64”(2mm) screw,
ensure a smooth non-binding movement.
Install the tail wheel hatch (H) using 4 off 5/64x25/64”(2x10mm) self
tapping screws.
H
D
BOTTOM VIEW
Please ensure the hinges are securely
glued into place, any failure will cause a
crash.
22- ELEVATOR
23- TAILWHEEL
Fit the control
horns as shown
12