H-KING P 15B Mustang Berlin Express, Инструкция по эксплуатации, Страница: 12 / 15

X
Rudder push rod
Tail wheel push rod
4-49/64”
(120mm)
2-61/64”
(75mm)
Link the battery cable to an extension lead then
reposition the hatch and secure with CA glue.
Battery area
(if using a 4T engine)
Battery area
(if using a 2T engine)
1000-2500mah, flat Rx pack
BOTTOM VIEW
Hatch
Hatch
2-9/32”
(58mm)
2”(51mm)
2-61/64”(75mm)
FUSELAGE
BOTTOM
Elevator push rod
Elevator push rod
Tailwheel push rod
Rudder push rod
Throttle push rod
................2
....................3
2mm
Connector
Elev. servo
Rudder servo
Thrott. servo
X
Twin elevator pushrods
and rudder pushrod
D=5/64”(2mm)
Tail wheel pushrod
D=.050”(1.2mm)
3mm set Screw
2 mm
Elevator pushrod
ELEVATOR / RUDDER SERVO
X
3mm set Screw
2 mm
THROTTLE SERVO
Throttle pushrod
D=.050”(1.2mm)
BOTTOM VIEW
BOTTOM VIEW
24- SERVOS AND RX BATTERY
25- LINKAGES
Elevator push rod
Throttle push rod
If using a 4T engine.
Carefully cut a panel 2-9/32”(58mm) wide x 2-61/64” (75mm) long
through both the covering and the balsa wood 4-49/64" (120mm)
back from the servo compartment as shown. Remove this section
and this will reveal a built in battery box.
Install your Rx battery and ensure is it secure with rubber bands
or similar.
Install the rudder, elevator and
throttle servos and Rx switch if
using either 2T or 4T engine.
13