1
2
1
1
2
3
1
1
2
1
2
3
4
1
2
3
1
1
2
3
4
2
1
1
3
5
6
6
5
13
6
13
15
16
17
1
18
13
18
Figure 1
I. Assembling the dynamic panels
(minimum of two people)
:
Note:
Prepare a clean area to assemble and set up the track.
1 -
Position the flat edge of a wooden upright
(1)
on the floor, against a wall
as shown in
Figure 1
.
2 -
Insert one end of each of the fiber rods
(2)
(fitted with 2 ferrules
(12)
) in the 15 recesses in the upright
(1)
.
3 -
Offer up the second upright
(1)
facing the first one
in order to insert the other end of the 15 fiber rods
(2)
into it
(as shown in
Fig. 2
). Do this by moving the second upright
(1)
in gradually as assembly progresses: start by partially
inserting each rod
(2)
such that the 15 of them are located, before pushing the second upright
(1)
fully home.
Figure 2 (Top View)
Figure 3
Detail
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
NM246a-
Page 2
4 -
Fit 2 holding straps
(3)
to tie the 2 uprights
(1)
together: thread each end of straps
(3)
, from the inside of the uprights
(1)
,
through the slots provided for this purpose (as shown in
Figure 3
and
Detail Figure 4
).
5 -
Thread a triangular metal ring
(4)
through the ends of straps
(3)
, aiming it in the direction shown in
Figure 5
,
in order to obtain an assembled panel
(6)
(see
Fig. 6
): compress the uprights
(1)
inwards in order to fit the 2
nd
ring
(4)
.
6 -
Assemble one linking flat
(13)
at the end of the assembled panel
(6)
on the assembly side of following panels
*
, with
screws and bolts
(15)
,
(16)
et
(17)
like
Figures 6
and
7
. Stick a piece of baize
(18)
center under the flat
(13)
.
7 -
Turn the first panel
(6)
over, then determine its location to accommodate the 2 x 25.50 m tumbling track.
8 -
Insert 2 metal dowels
(5)
in the mating face of each upright
(1)
(like
Figure 8
) on the same side of the flats
(13)
.
9 -
Repeat the above procedure for the 16 remaining panels
(6)
(only the last panel does not have any dowels
(5)
).
10 -
Make the 17 panels
(6)
jointly liable: Put the first panel
(6)
dowels
(5)
in the following one like shown on
Figure 9
, then
fix the linking flat
(13)
from one panel
(6)
to the following one with remaining screws and bolts
(15)
,
(16)
et
(17)
.
11 -
Complete in the assembly of end flat
(14)
on the first and the last panels
(6)
of the track, without forgetting pieces
(18)
.
Figure 9