5.INVERTER INSTALLATION
This section describes generation installation instructions for the power inverter.
IMPORTANT: Use a qualified installer if you do not possess the knowledge and skill
necessary to follow these general instructions.
5.1 PREPARE FOR INSTALLATION
Design your power system
Calculate your battery requirements
Choose an effective charging system
Choose an appropriate location
Prepare cables for DC input and ground
Determine how you are going to use your inverter then design a power system that will
give you maximum performance. The configuration shown below is some typical
power system design, only for reference.
colored black.
2. Positive DC input terminal always connects to the positive terminal of the battery
via a positive DC input cable (red battery cable).the positive DC input terminal is
colored red.
3. Chassis ground screw connects to vehicle chassis, DC grounding bus or to engine's
negative bus 3 or grounding the earth.
4. Ventilation openings must not be obstructed for the proper operation of the
inverter. When the inverter is mounted, then ventilation opening on the DC panel
must not point up or down
4.2AC PANEL
5. Fault light (red) indicates that the inverter has shutdown due to inverter overload,
over temperature, short circuit, and leakage or failure status.
6. Power Light (green) indicates the inverter is operating.
7. AC OUTLETS are used to power loads
8. USB port it output DC5V 2.1A for charge for your appliance.
9. ON/OFF SWITCH turns the Inverter on and off.
10. Remote ON/OFF connector port is used for connecting the ON/OFF remote switch.
5.2 POWER SYSTEM CONNECTION EXAMPLE
Figure 4 Typical power system designs
5.3 BATTERY REQUIREMENTS
Battery type and battery size strongly affect the performance of the power inverter.
Therefore, you need to identify the type of loads your inverter will be powering and how
much you will be using them between charges. Once you know how much power your
need. We recommend that you purchase as much battery capacity as possible.
5.4 CHARGING SYSTEM:
The charging system must be appropriate for your particular installation. A well-designed
charging system will ensure that power is available when you need it and that your
batteries remain in top condition. Inadequate charging degraded system performance
and the wrong type of charger will reduce battery life.
Contact us or visit our website to find more information about our different battery
chargers.
The power inverter must only be installed in a location that is:
DRY The inverter must be installed in a dry location not subject to moisture especially
rain, spray, or splashing bilge water.
COOL The inverter should not be exposed to metal fillings or any other form of
contamination.
VENTILATION The ambient air temperature should be between 0-40
℃
(32-104 F) for best
performance.
6. INVERTER LOCATION
5V
2.1A
Содержание 2221315
Страница 1: ...2221315 Inverter ...
