2
Table of Contents
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Typical Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Wiring Diagrams . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Wiring Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Hardware Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Installation - New Construction . . . . . . . . . . . . . . . . . . . . . . . . 8
Installation - Existing Construction . . . . . . . . . . . . . . . . . . . . 10
Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Safety Information
READ AND SAVE THESE INSTRUCTIONS
PLEASE READ AND UNDERSTAND THIS ENTIRE
MANUAL BEFORE ATTEMPTING TO ASSEMBLE,
OPERATE, OR INSTALL THE PRODUCT .
□
Always disconnect the power supply prior to servicing the fan,
motor, or junction box.
□
Follow all local building, safety, and electrical codes as well as
the National Electrical Code (NEC) and Occupational Safety and
Health Act (OSHA).
□
Electric Service supply must be 120V, 60 Hz.
□
This product must properly connect to the supply circuit’s
grounding conductor.
□
Do not bend or kink the power wires.
□
Do not use this fan with any solid state control device, such as
a remote control, dimmer switch, or certain timers. Mechanical
timers are not solid-state devices.
□
Do not install in a ceiling with insulation greater than R40.
□
Duct work should be installed in a straight line with minimal
bends.
□
Duct work size must be the same size as the discharge and
should not be reduced. Reducing the duct size may increase fan
noise.
□
If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application. When the fan is
going to be installed in the bathroom, the fan and the tub must
be more than 1.0 meters between each other. The fan must be
installed at the other side of the tub in ceiling. Acceptable for
use over a bathtub or shower when installed in a GFCI-protected
branch circuit.
WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Use this unit in the
manner intended by the manufacturer. If you have any
questions. Please call customer service.
WARNING:
Before servicing or cleaning the unit,
switch the power off at the service panel and lock the
service. Disconnect or disable any means by which the
power can be switched on accidentally. When the service
disconnection means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
WARNING:
Installation work and electrical wiring must
be done by a qualified person(s) in accordance with all
applicable codes and standards, including fire-rated
construction.
WARNING:
Sufficient air is needed for proper combustion
and exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent backdrafting. Follow
the heating equipment manufacturer’s guideline and
safety standards such as those published by the National
Fire Protection Association (NFPA); the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE); and local code authorities.
WARNING:
When cutting the ceiling, do not damage
electrical wiring or other hidden utilities.
WARNING:
Ducted fans must always be vented to the
outdoors.
CAUTION:
For general ventilation use only. Do not use to
exhaust hazardous or explosive materials and vapors.
CAUTION:
Not for use in cooking areas.
CAUTION:
To reduce the risk of injury to persons, install
the fan at least 8 ft. (2.5 m.) above the floor.
