- 9 –
•
Press and hold the Learn Button a third time for two seconds. Release the Learn
button. The light will blink green five times. And you will hear five beeps,
confirming that the new code has been accepted. If the red light blinks three times
with three soft beeps at this point, and error has occurred. Just start over by
depressing the Learn Button for two seconds.
3. Turning off Keypad Sound
To disable the Keypad Sound (beeps), press and hold the Learn Button for two seconds,
three times. The green light will blink three times and you will hear three beeps. Release
the button. Then press and hold buttons two and three for five seconds. The Keypad
Sound is now disabled, but this does not disable the alarm sound.
4. Tamper Detect Feature
Entering an invalid access code sets the tamper indicator.
Hold down buttons two and three for five seconds to read the tamper indicator.
•
If tampering has been detected, the red light will glow until buttons two and three are
released.
•
If tampering has not been detected, the green light will glow until buttons two and
three are released.
5. Security Sleep Mode
The GunVault safe has a “Security Sleep Mode” that activates when 24 consecutive
incorrect entries are made (if the correct code is entered within 24 entries, the door will
open). During Sleep Mode the keypad does not accept any entries and last for two
minutes. If a button is depressed during Sleep Mode, the LED blinks red and the alarm
beeps three times. The backup key may be used to open the safe during sleep mode.
6. Mounting the Safe
The Vault can be mounted in almost any direction. Think carefully before you begin to
drill holes; make sure you could easily reach the keypad, but protect the safe from
children.
IMPORTANT: Do not mount the Vault
with the door facing down! The contents
could fall out when the door is opened!
Think about your own unique mounting
requirements. You may wish to use
washers, lag bolts, or other mounting
devices for reasons of your own.
Compare the Mounting Template to the
safe. Notice the mounting holes in the
bottom of the safe. There are two “key-
slot” holes, and four round holes.
