- 10 –
a)
Using the template provided, drill starter holes with drill bits appropriate for your
installation. Drive screws only into the two key-slot holes. Drive the screws in until
just enough room is left between the head of the screw and the mounting surface to
permit you to slide the Vault’s key slots over the screws.
b)
Slide the Vault key-slots on over the screws.
c)
Now lift the foam padding in the bottom of the Vault and insert screws into remaining
holes as desired, to retain the safe in place. A minimum of three (3) screws must be
used to mount the safe.
d)
Tighten all screws and smooth the foam lining. Your Vault is now securely attached
to the mounting surface!
7. Installation of Optional Security Cable
“Knock-outs” are provided on both sides to permit attachment of the Security Cable. If
the Security Cable is to be installed, use a punch or nail set and a hammer to remove the
knock-out. Before inserting cable mount, be sure to remove the little metal knock-out tab
from your safe. Do not allow this small metal piece to remain inside your safe.
Hint: A pair of needle-nosed pliers will be useful for installing the hitch pin.
a)
First, loop the end of the security cable through the eye and around a stationary
object.
b)
Then, insert the threaded mount through the hole in the safe.
c)
Hold the mount in place while you slide the star washer over the threaded end inside
the safe.
d)
Spin on the nut and tighten “finger tight.”
e)
Insert the Hitch Pin through the hole in the threaded mount, to ensure that the nut
cannot come off.
8. Motion Detection and Alarm Features (Deluxe Models Only)
Deluxe Model GunVault safes are equipped with Motion Detectors and Audio Alarms.
Once armed, this system will protect the safe and its contents if either one of the
following occurs:
1.
Twenty-four wrong entries are entered into the keypad in succession.
2.
The safe is moved or disturbed.
•
If the Motion Detector is armed, shock, vibration or motion of any kind may trigger
the Audio Alarm.
•
If the alarm is triggered, a four second continuous tone will sound, followed by 25
short audio ticks, indicating that the alarm is about to sound.
