Gulf Coast Spas DX 5000, Руководство пользователя

Страница: 26 / 52

24
O p e r a t i n g I n s t r u c t i o n s
Setting the Water Temperature
Use a temperature button to set the water temperature you desire.
The temperature setting displays for five seconds to confirm your
new selection. The set point icon indicates that the display shows
the desired temperature (not the actual water temperature). The
default temperature setting is 100ºF.
Setting the Filtration Cycles
To set the filtration cycle start time, reset the controller by power
cycling (power off). After the five minute priming, the filtration
cycle starts 12 hours later. You can also skip the priming period by
pressing a temperature button.
To change the filter cycle setting:
Filter duration is programmable for 2, 4, 6, 8 hours or for continuous
filtration (indicated by “FC”). The default filter time is 2 hours. To
program, press Up/Down button, then Jet. Press a temperature
button to adjust. Press Jet to exit.
When Jets LED is ON and the Heat LED is OFF, the spa is in filtration
mode.
Covering Your Spa
Place the insulated cover on your spa. Keeping the cover in place
anytime the spa is not in use reduces the heating time and
minimizes operating costs. The time required for initial heat-up
varies depending on the starting water temperature, ambient
temperature and the capacity of your spa.
Water Chemistry
Once your spa reaches 90ºF or higher, add the start-up AquaClara
Natural spa care system (if equipped, see page 22) to the water.
Turn Pump 1 on high speed immediately after you add AquaClara
Natural to the water to evenly distribute AquaClara through your
system.