6
Code Switch Location and Adjustment
The code switches are located inside of the transmitter on the backside of the circuit
board, above the battery.
1. Remove any static charges from your body by touching a grounded metal object.
2. Remove wireless transmitter from console mounting bracket, by slightly bending the
tab back to release the transmitter from the bracket.
3. Remove the two screws on the back of the transmitter with a Philips screwdriver.
4. With a coin, lightly pry open the transmitter case using the slot in the bottom corner
opposite the key ring hole.
5. Carefully separate the case halves.
6. Carefully remove the circuit board and adjust the code switches to a new setting,
(See figure A for switch location).
a.
The position of each of the eight switches may be changed by using a small
stiff object such as the end of a paper clip, or the end of a mechanical
pencil with the lead retracted
b.
NOTE:
It does not matter which code is chosen provided that all wireless
transmitters in the system are set to the same code.
1.
2.
Wireless
remote
PCB.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
