4
5. Place the 12 Volt Alkaline A23 battery in location per Figure 1 below paying close
attention to the + / - orientation.
NOTE:
If you wish to change the security code for your light, skip to the section titled:
Changing the Security Code – OPTIONAL
6. Make sure membrane and top cover is re- assembled correctly with buttons
protruding fully.
7. Carefully snap top cover / membrane on to lower assembly. It should only take
light pressure to snap in place.
8. Test battery connection by pressing any of the buttons. When doing so, the red
LED indicator should turn on in the upper left hand corner. If the LED does not
illuminate, separate the covers and check the battery polarity, if battery polarity is
correct, replace the battery.
FIGURE 1
9. Re-install the 2 screws on the back cover and tighten them.
LED location
Downloaded from
Downloaded from
Downloaded from
Downloaded from
