Single Guerrilla Bypass kit
Dual Guerrilla Bypass kit
Introduction
The instructions in this installation manual guide you step by step to a
correctly working Guerrilla Bypass in the existing exhaust system of
your car.
Tips in advance:
•
Install the Guerrilla Bypass just before the end muffler for the
best sound.
•
Cones and other accessories are available at
http://www.guerrilla-exhaust.com
•
Don’t want to install yourself? Contact us for an appointment.
1 | Installing the electrical part
1.1 | Installing the receiver unit
Place the receiver unit near the battery in the engine or cargo
compartment.
Please note:
Do not place the receiver unit in the vicinity of hot parts (such as the
radiator, the exhaust manifold or the engine block) or in a place where
it is exposed to splash water. Any such damage voids the warranty.
1.2 | Laying the wiring harness
The wiring harness has ready-to-use connections. The power cable
contains a splash-proof fuse holder. The other end is equipped with a
splash-proof connector that is suitable for placement under the vehicle.
•
Carefully roll out the wiring harness to full length and ensure it
is free of kinks.
•
Start at the battery and route the wiring harness, via the
receiver unit, towards the bottom of the vehicle, with sufficient
distance from moving or hot parts. Provide clearance in suitable
areas.
Tip:
Wrap the visible parts of the wiring harness in linen tape for a more
original ("OEM") appearance.
