3.
Check the shaft lock position (Fig. 4). The shaft
has to be unlocked for operation.
Planing effect is unclean
1. Exhaust
unavailable.
2.
Plane cutting block blunt.
1.
Always work with the unit equipped with exhaust.
The planing result will improve.
2.
Replace the plane-cutting block with genuine
spares.
Inspections and Maintenance
Always unplug the unit before adjustment and maintenance !
Fig. 10
Loosen the blade retaining screws and carefully remove the clamp
plate. The blade may be removed and replaced with a new one. Mind
the direction of placing the blade.
Carefully put the clamp plate on the plane blade and tighten the
screws with hand.
Continue setting up –see Fig. X.
Tighten the screws and fix them in place.
When a blade is being replaced, both the blades have
to be replaced.
Fig. 11
To set up the blade, the retaining screws have to be released so that
the blade can be moved.
Use an adjusting ruler (1) (if available) or a metal bar (2) to set the
edge overlap.
The maximum edge overlap over the output table is 0.1 mm.
Fix the adjustment with retaining screws.
Check the set-up several times. It is recommended to
check the set-up at 3 points along the cutting width at
least.
Inspections and Maintenance Safety Instructions
The machine will serve as a sufficient aid only if maintained and care for appropriately. Insufficient maintenance and care may result
in accidents and injuries.
Inspections and Maintenance Schedule
Time interval
Description
Other details if
necessary
After every use
•
Wipe the unit with clean dry cloth or blow it with low-pressure pressure air
As needed
•
Clean the motor vents to avoid overheating.
•
Replace the plane-cutting block.
18
